In dealing with a cross cut sled-to-box joints

!9# In dealing with a cross cut sled-to-box joints

[if ]

[endif]

A crosscut sled can be used for many applications of wood. Familiarity with him joint box is one of my favorites.

What you need:

A table knife with NUT.
A Cross Cut Sled
From 3 / 8 stop "X 3 / 8", "X 1 wooden Index
Pretty 3 / 8 "X is the desired stock level of a field box to the desired size.

Instructions for making box joints with a sledge Cross Cut:

Cut the soup into 4 parts. The shares will be cut into lengths of two sides ofand 2 each for the ends. This should be the length of the outer box. Set the blade to cut a NUT 3 / 8 "groove. Cut a groove in the ground with the blade slide NUT. Install 3 / 8" X 3 / 8 "X 1" indicates exactly 3 / 8 stop "away and parallel to the cut on the right side of the blade on the floor of the carriage. Adjust the height by adjusting the blade height of the floor transport and NUT 3 / 8 ". You can insert a piece of your 3 / 8 relevance to transport and carry the blade until it is even with thetop of the field.

Times over the stock photos and repeat other side. Do both sides the same way. Then trim the ends. This time, start by checking the closure of the camp next stop for the index. This is compensated for the cuts on the final pieces of the end 3 / 8 ", that can be addressed on the joints.

In dealing with a cross cut sled-to-box joints

Sona Med Spa Reviews Saved Bowflex Selecttech 1090 Dumbbell !9# Bagless Upright Vacuum Helix